加拿大华人论坛 加拿大生活信息二手买卖 - 4寸平板灯

在加拿大

DescriptionLED RECESSED FLAT PANEL LIGHTINGColor Temperature: 3000K warm white WW /4000K neutral white NW /5000K cool white Lumens:780lm(5000k) / 760lm (4000k) / 750lm (3000k) Beam Angle: 110º Dimmable Power: 12W Frequency: 60Hz CRI: ＞80 PF: 0.95 Volts: 120V AC Life: 50000HrsType IC Rated-approved for direct contact with insulations.Assembly Instructions:1.Risk of electric shock- turn off power before inspection, installation or removal.2.Locate a suitable position to place the LED fixture and open a hole in accordance with the cut-hole dimensions (refer to Hole Cut Table for appropriate size).3.Run the electrical wire from the switch (power supply), through the mounting hole-use NMD90 OR BX cable.4.Open the hardwire box swing cover and remove the appropriate knockout(s).5.Insert the electrical supply cable through the knockout.6.Wire box using supplied quick connect push-in terminals. Connect green ground wire of cable to green wire of box. Connect white wire of cable to white wire of box. Connect black wire of cable to black wire of box.(Fig. 1).7.Place all wiring and connections back into the box and close the cover.8.New construction applications: Junction box shall be firmly secured to studs, joists, or similar fixed structural units.(Fig.2)9. Remodel applications: Do not require the junction box to be firmly secured to the mounting plates, studs, joists, or structural units that have been concealed. Snap off the junction box tabs(Fig.3), then insert into the ceiling(Fig.4).10.Push spring loaded clips on the fixture upwards and insert fixture base into the mounting hole. Release the clips and fixture will be pulled flush to the ceiling(Fig.5).11.Once the assembly is complete, turn on power to confirm fixture is working properly. Hole Cut Size:∅4-3/32"（104mm）Tools Required: ●Saw ●Measuring Tape ●Electrical Wiring (use type and gauge suitable for application to connect the fixtures).SAFETY: For your safety, this fixture must be wired in accordance with local electrical codes and ordinances. All work should be done by a qualified electrician.Warning: Make sure power is OFF from the electrical panel before starting the installation or attempting and maintenance. For indoor installation only. Order online https://www.nvcled.ca/shop?olsFocus=false&olsPage=products/dawnray

  ·生活百科 日元贬值好，买老虎电饭锅
·福利政策 Medicare Card一般多久可以下来